Removal and installation of a flywheel. BMW the 7th E38 series (from 1994 to 2002 release)
 
BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
4.1. General information and preparatory operations
4.2. Check of compression pressure
4.3. Check of the engine by means of the vacuum gage
4.4. Petrol M60/1 and M60/2 engines
4.4.1. Removal and installation of a cover of a head of cylinders
4.4.2. Removal and installation of a head of cylinders, adjustment of phases GRM
4.4.3. Removal and installation of the top section of the pallet of a case
4.4.4. Removal and installation of the pallet of a case
4.4.5. Removal and installation of covers of a chain of GRM
4.4.6. Replacement of epiploons of a bent shaft
4.4.7. Removal and installation of a flywheel
4.4.8. Removal and installation of belts of the drive of auxiliary units
4.4.9. Removal and installation of a damper of tortional fluctuations and its nave
4.4.10. Removal and installation of the oil pump
4.4.11. Removal and installation of the inlet pipeline
4.4.12. Removal and installation of final collectors
4.4.13. Removal and installation of the engine
4.5. M62 engine
4.6. Diesel M57 engine
4.7. Diesel M67 engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



4-4-7-snyatie-i-ustanovka-makhovika.html

4.4.7. Removal and installation of a flywheel

 PERFORMANCE ORDER

  1. Remove RKPP together with coupling or AT (see the Head the Manual box of gear shifting and coupling or Automatic transmission).
  1. Record a flywheel by means of special adaptation No. 11 2 070.
  1. Turn out bolts of fastening of a flywheel by means of special adaptation No. 11 4 180 and remove a flywheel.
  1. On a flange of a bent shaft clear carving openings under bolts of fastening of a flywheel.
  1. The provision of a two-mass flywheel is fixed by the special shortened plug (1) which position on a flywheel is noted by two vents near the corresponding carving openings.
  1. Slightly oil a carving of bolts of fastening of a flywheel motive and tighten them with the required effort.


"previous page
4.4.6. Replacement of epiploons of a bent shaft
following page"
4.4.8. Removal and installation of belts of the drive of auxiliary units