Removal and installation of the lock of ignition and blocking of a steering wheel. BMW the 7th E38 series (from 1994 to 2002 release)
 
BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism from GUR
12.5.8. Removal and installation of steering drafts, bipod and pendular lever
12.5.9. Removal and installation of the pump GUR
12.5.10. The angles of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-5-6-snyatie-i-ustanovka-zamka-zazhiganiya-i-blokirovki-rulevogo-kolesa.html

12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel

 PERFORMANCE ORDER

  1. Remove the top bearing of a steering shaft and the top casing of a steering column (see the Section Removal and installation of casings of a steering column).
  2. Remove the ring antenna of the EWS system.
  3. Remove arms of understeering switches (see the Head Onboard electric equipment).
  1. At the corresponding complete set disconnect draft of the Interlock system.
  1. Turn out a bolt and remove the holder of a plait of an electrical wiring. Separate the ignition lock electrical wiring socket.
  1. Cut off a head of the disposable screw, remove a plate (1) and the lock (2) shaft of a steering wheel.

At installation tighten the disposable screw to an obryvaniye it on a neck.

  1. Remove the cylinder of the lock and to put the new lock of a shaft of a steering wheel.
  1. Remove a protective varnish, turn out control screws and install the ignition switch on the new lock of a shaft of a steering wheel.

At installation paint over heads of secret screws.

  1. After installation check functions of the lock of ignition and understeering switches.


"previous page
12.5.5. Replacement of the lever of adjustment of a steering column
following page"
12.5.7. Removal and installation of the steering mechanism from GUR