Replacement of the lever of adjustment of a steering column. BMW the 7th E38 series (from 1994 to 2002 release)
 
BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism from GUR
12.5.8. Removal and installation of steering drafts, bipod and pendular lever
12.5.9. Removal and installation of the pump GUR
12.5.10. The angles of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-5-5-zamena-rychaga-regulirovki-rulevojj-kolonki.html

12.5.5. Replacement of the lever of adjustment of a steering column

Design of the lever of adjustment of a steering column

1 — the Nut
2 — the Bearing
3 — Tightening a disk

4 — the Clamp
5 — the Lever
8 — the Torsion spring
9 — Tightening adaptation


 PERFORMANCE ORDER

  1. Remove the top and lower casings of a steering column (see the Section Removal and installation of casings of a steering column).
  2. Remove the wooden panel and the finishing panel of a ware box at the left.
  3. Release the torsion spring (8) on both sides, give a nut (1) and remove the persistent bearing (2), tightening a disk (3) and a clamp (4).
  1. Vypressuyte by means of special adaptation No. 32 1 200 and a nozzle No. 32 1 204 tightening adaptation (9) from the lever (5) of adjustment of a steering column. Hold adaptation for lysk with a wrench.
  1. The lever of adjustment has to look at the lock of a shaft of a steering column, and the tetrahedral head of tightening adaptation should be brought to an opening of a pipe of an arm of fastening of a steering shaft.
  1. Press tightening adaptation (9) by means of special adaptation No. 32 1 200 in the lever (5) of adjustment of a steering column. Put on a clamp (4), tightening a disk (3) and the persistent bearing (2). Insert the torsion spring (8) on both sides.

Replace a nut (1).



"previous page
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
following page"
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel