BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
12.5.1. Principle of work of GUR
12.5.2. Removal and installation of a steering wheel, block of a safety cushion and its contact ring
12.5.3. Removal and installation of casings of a steering column
12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation
12.5.5. Replacement of the lever of adjustment of a steering column
12.5.6. Removal and installation of the lock of ignition and blocking of a steering wheel
12.5.7. Removal and installation of the steering mechanism from GUR
12.5.8. Removal and installation of steering drafts, bipod and pendular lever
12.5.9. Removal and installation of the pump GUR
12.5.10. The angles of installation of wheels of the car - the general information
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-5-4-snyatie-i-ustanovka-sborki-rulevojj-kolonki-i-datchika-ugla-povorota.html

12.5.4. Removal and installation of assembly of a steering column and sensor of an angle of rotation

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the rechargeable battery.
  2. Remove a steering wheel (see the Section Removal and installation of a steering wheel, block of a safety cushion and its contact ring).
  3. Remove the lower section facing of the dashboard (see the Head Kuzov).
  1. Remove a ring with bore (1).

At installation pay attention to the provision of a ring (1) in relation to a spring lock ring (2).

  1. To remove the top casing of a steering column (see the Section Removal and installation of casings of a steering column).
  1. At the corresponding complete set disconnect draft of the Interlock system from the ignition lock.
  1. Turn out tightening a bolt and press on a steering shaft of the helmsman in the direction down.

At installation replace самоконтрящуюся nut.


  1. If necessary remove the sensor of an angle of rotation from a steering shaft.
  1. Cut down the disposable screw a chisel or cut off its head.

At installation install the expansion plug and tighten the disposable screw to an obryvaniye it on a neck.


  1. Disconnect all wires conducting to a steering column, turn out the screw and separate the ignition lock socket.
  1. On models with automatic adjustment turn out bolts (3).
1 — the Arm
2 — Prostavochnaya the plug
3 — the Bolt
4 — the Plastic plug
5 — the Washer
6 — Samokontryashchayasya a nut (8 Nanometers are subject to replacement)
  1. Turn out bolts of fastening of the bearing pipe and remove a steering column.
  1. Installation is made upside-down. After installation:
    • Establish compliance between an angle of rotation for the EDC and DSC systems and the actual corner.
    • Check freedom of the course of a steering column on all range of adjustment in relation to the next details/pipelines.


"previous page
12.5.3. Removal and installation of casings of a steering column
following page"
12.5.5. Replacement of the lever of adjustment of a steering column