Removal and installation of the stupichny bearing. BMW the 7th E38 series (from 1994 to 2002 release)
 
BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation of a suspension bracket assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-2-6-snyatie-i-ustanovka-stupichnogo-podshipnika.html

12.2.6. Removal and installation of the stupichny bearing

After dismantling the knot of the stupichny bearing is subject to replacement.


 PERFORMANCE ORDER

  1. Remove a brake disk (without disconnecting a brake hose) of and the wheel sensor of the ABS system (see the Head the Brake system).
  1. Take off the screw-driver a nave cap.

At installation use a new cap.


  1. Koronchaty nut also give to Razkontrita it, having used, for example, key No. 31 2 080.

At installation use a new nut.


  1. Remove bearing knot by means of adaptation No. 33 2 116/33 4 201/202/203 and wheel bolts (1).
  1. If necessary remove an internal ring of the bearing from the end of a beam of a suspension bracket by means of special adaptation No. 33 4 402. For this purpose put on adaptation No. 33 4 406/401 an internal ring of the bearing and squeeze until adaptation hardly is turned.
  1. As an alternative for removal of a boot and an internal ring of the bearing it is possible to use adaptation No. 31 2 100, previously having removed the protection cover.
  1. Establish laying (1) on a new boot (2).
  1. Install the protection cover (1) and a new boot (2).

The opening in a boot has to be coaxial to an opening in a rotary fist. Screw against the stop a mandrel No. 31 2 110.


  1. Spread new knot of the stupichny bearing and its napressuyta by means of a mandrel No. 31 2 110.
  1. Screw a new koronchaty nut, tighten it with the required effort and a zakontrita, tapping on it.

At percussion the nut has to be recorded in a flute!

  1. Establish a new cap on sealant.
  2. Install the wheel sensor and a brake disk.


"previous page
12.2.5. Removal and installation of a rotary fist
following page"
12.2.7. Removal and installation of the stabilizer of cross stability and its rack