Removal and installation of a rotary fist. BMW the 7th E38 series (from 1994 to 2002 release)
 
BMW 7_aya the E38 series from 1994 to 2002
1. Introduction
2. Governing bodies and methods of operation
3. Settings and routine maintenance of the car
4. Engine
5. Cooling systems of the engine, heating, ventilation and air conditioning
6. A power supply system and production of the fulfilled gases
7. Systems of electric equipment of the engine
8. Manual box of gear shifting and coupling
9. Automatic transmission
10. Cardan and power shafts, reducer, differential and stupichny assemblies
11. Brake system
12. Suspension bracket and steering
12.1. General information, recommendations and security measures
12.2. Forward suspension bracket
12.2.1. Removal and installation of a suspension bracket assembled
12.2.2. Removal and installation of a beam of a suspension bracket
12.2.3. Removal and installation of the left or right cross lever of a suspension bracket
12.2.4. Removal and installation of extensions of levers and hinges of extensions
12.2.5. Removal and installation of a rotary fist
12.2.6. Removal and installation of the stupichny bearing
12.2.7. Removal and installation of the stabilizer of cross stability and its rack
12.2.8. Removal and installation, dismantling and assembly of a rack of a suspension bracket
12.3. Back suspension bracket
12.4. EDC system
12.5. Steering
13. Body
14. Onboard electric equipment
15. Schemes of electric equipment



12-2-5-snyatie-i-ustanovka-povorotnogo-kulaka.html

12.2.5. Removal and installation of a rotary fist

 PERFORMANCE ORDER

  1. Remove the stupichny bearing (see the Section Removal and installation of the stupichny bearing).
  2. Remove the protection cover of a rotary fist and the forward wheel sensor of the ABS system (see the Head the Brake system).
  1. Give a nut and a vypressuyta cross steering draft by means of a stripper No. 31 1 190.

At installation on landing cones there should not be lubricant traces; use new самоконтрящуюся nut.

  1. Remove the cross lever of a suspension bracket (see the Section Removal and installation of the left or right cross lever of a suspension bracket), its extension (see the Section Removal and installation of extensions of levers and hinges of extensions) and a rotary fist.
  2. Installation is made upside-down. After completion of works check and adjust the angles of installation of forward wheels.


"previous page
12.2.4. Removal and installation of extensions of levers and hinges of extensions
following page"
12.2.6. Removal and installation of the stupichny bearing